Our company provides services for the assembly of printed circuit boards using surface mount technology, mounting of electronic components in the hole, as well as their combination.
Manufacturing of single samples - by hand; in small-scale and serial production, manipulators and a convection reflow oven are used. The boards are washed, if necessary, a protective varnish is applied. It is possible to manufacture cable and harness products, assemble and mount boards in housings, complete products with purchased electronic components.

Stages of PCB assembly:
• Automated or manual assembly of components on the surface of printed circuit boards;
• Double-sided SMD mounting;
• Combined assembly of components: both in the holes of printed circuit boards and on the surface;
• Cleaning of printed circuit boards is in progress;
• If necessary, apply a protective varnish;
• Assembly and installation of boards in housings;
• Manufacturing of cable and harness products;
• 100% inspection of the finished product.

PCB Design Requirements:
• The maximum size of the printed circuit board is 500x400mm. 50 * 60cm
• Small boards should be multiplied.
• All contact pads must be separated from each other with a solder mask.
• Along the long sides of the PCB, SMD components should be at least 3.5mm from the edge of the PCB.
• The board must have two reference marks located in the diagonal corners no closer than 5mm from the edge of the board.
• In any case, it is strongly recommended that you agree on the design of the PCB before placing an order for its manufacture.

Component requirements:
• Components must be supplied in their original packaging and in full. The belt with the components must have a filling end of at least 10 cm.
• Chip components are shipped with a 2% stock. All surplus will be returned to the customer after the order is completed.

The entire range of 5% resistors and capacitors, standard sizes 0805 and 1206, are always in stock.
To prepare for production (making a stencil and drawing up a program for automatic installation of SMD components), you must provide a drawing in the format of the design system in which the printed circuit board was developed.
The files of the following design systems are accepted:
• P-CAD2001 - P-CAD2006
• Altium Designer
• Eagle
• KiCad
• Proteus
 
Price:
The cost of installation services depends on the batch of products, the number of components and the number of solder points. Please send your inquiries to estimate the cost of services.